![]() Spray aprox 4 - 6 inches from the surface for best results.Ħ) Clean-Up: The Refinisher will now pull the tape and paper away from the surrounding area and clean up the area surrounding as well as possible. Spray 3 light - medium coats at medium air pressure. Let sit for 5 min to activate then stir again prior to spraying. *Mix resin and catalyst 1:1 for standard bathtub use 8oz plus 1-2 oz of reducer if needed. Make sure the spray is light and even and you should have no problem with the paint dripping.ĥ) Top-Coat Application: Most professional refinishers will apply between 3 and 4 coats of NuGlass 500 high-gloss aliphatic acrylic urethane. ![]() When you’re spraying verticle walls, such as tile spray from side to side rather than up and down, always start from the top and work your way down. Allow the strokes to over lap slightly but always spray in a single direction. ![]() Try to cover the entire length of the masked off area in one long stroke. When spraying use long sweeps with spray gun to avoid drips. Allow 15-20min dry time before applying topcoat. Spray aprox 3 - 4 inches from the surface for best results. Spray 2 light - medium coats at medium air pressure. Use a smaller needle size for primer and topcoats. Between 2 and 3 coats are applied with a professional HVLP system covering the surface of the fixture completely. At this point, the refinisher will cover the immediate area surrounding the fixture with paper and tape.Ĥ) Primer Application: NuPrimer 1000 is an epoxy primer used to create an effective mechanical bond when applied to a clean, dry, porous surface. ANY water on the surface will completely nullify the bond between the surface and primer to be applied. The exposed ceramic will enable a good mechanical bond between itself and the epoxy primer applied in following steps.ģ) Area Protection: After completely rinsing the acid down your drain, the refinisher will then use his turbine air compressor to blow out all the edges of the tub and the drain to remove and dry any water and acid that may be left in the cracks. Simply brush on TileEtch over the entire surface to be sprayed and leave on for 10 min before rinsing off with water. This methode is a great alternative to sanding the entire surface which will leave a uniform, dull surface without the problem of creating scratch marks. Silicone will NOT allow coatings to stick and therefore must be removed completely.Ģ) Hydrofluoric Acid Etching or Sanding: TileEtch is used at this point to completely eat off the glaze, or shine, on the fixture to expose the ceramic underneath. This includes razor scraping along with sanding the surface to completely remove all residue. HOW TO REFINISH A BATHTUB - STEP BY STEP INSTRUCTIONS:ġ) Caulk Removal: Every quality refinisher will remove all caulk surrounding the fixtures being refinished. Sand Paper / Palm Sander / Scraping bladeĪdditional things you’ll need for countertops refinishing. Looking to start refinishing bathtubs but not sure where to start? Here’s a check list of things you’ll need. When using MultiColor Paint on surfaces that will take physical and chemical abuse such as bathtubs, sinks, ceramic tile and countertops, MultiColor MUST be clear coated. ![]() Spray 2 to 3 even coats of MultiColor over surface until look is s achieved. Primer surface with NuPrimer 1000 and let dry for 15-20 minutes before applying the NuStone MultiColor you are using, this in not required but helpful. Tack down surface with tack cloth before primer is applied. Lightly sand surface with 220 grit sandpaper before primering. MultiColor paint is an affordable alternative to a granite look that is designed to be virtually odorless and durable for all surfaces including bathtubs, tile and countertops.Īpproximate coverage with one gallon of multispec: 120 - 150 SQFT
0 Comments
Leave a Reply. |